Hi, Can anyone help? I am building Amati's Riva kit & as you know the hull is a big resin lump! Before i get too far into the lovely bits of dashboard, planking & veneers etc,.i thought i would have a go at preparing the "engine room" & propeller shaft arrangement.A fair bit of "gouging" out is required to make sure the twin motors & other electric bits fit o.k. to say nothing of the rudder arms. Any way, i have made an alignment error & drilled the prop-shaft tunnels in the wrong place (i know, Measure twice & Drill once)!!
Does anyone have a foolproof method of filling the wrongly drilled tunnels & what would be the best material to use? All suggestions gratefully recieved.
Thanks everybody. JohnHA.
