| Jeff,the main ingrediant is tuolene based filler,this etches into the plastic surface slightly and can be very difficult to remove,you could try cotton wool buds carefully dipped in acetone,but be careful as it will eat into the plastic,best mask either side of the work in hand,just stroke the joint with the bud and remove any surplus with a lint free cloth,do the job outside in the fresh air,work slowly and carefully.
__________________ 'And there I was oil on my goggles from a broken pipe,then I looked at the altimeter,all I could see was the makers name !' www.wonwinglo.scale-models.net/ |