| Paul.
Doesn't look too bad from this end of the box
I use Tamiya acrylics too with no probs , just thin them with tamiya thinners.
be wary of using enamel and acrylic together, I believe 1 will go over the other but not the other way around I have seen some nasty chemical reactions between them.
Think you may have some of the release agent still in the hull, sometimes you get a bleed through if its not been laid just right.
Did you use a good undercoat first ??
Always a good idea, shows you the high / low spots and can help seal the fibreglass and will highlight any probs prior to finishing.
Not an expert but just don't appear to have probs with paint etc
Best regards Sub. |