HpH 1/32 Catapult for an Arado 196A

G

Graham D

Guest
Here is the "sprue" shot, for the HpH catapult. I will be using this as the stand for the Arado 196A

sprue1.jpgsprue2.jpgsprue3.jpg
These bits make up the base. The instructions say to put weight of 750g to 1kg in the base.

sprue4.jpg
This is the main track of the catapult, to give a sense of scale, it is 44cm long.

sprue5.jpgsprue6.jpgsprue7.jpgsprue8.jpgsprue9.jpgsprue10.jpgboxart.jpg
 
Last edited by a moderator:

Ian M

Administrator
Staff member
Administrator
Moderator
SMF Supporter
Joined
Dec 14, 2008
Messages
19,584
Points
113
Location
Falster, Denmark
First Name
Ian
Rather a rude question, how much did that cost. If you do not want to say, that's ok, I just might have use for one later.
 

Mr Bowcat

SMF Supporter
Joined
Dec 29, 2016
Messages
3,634
Points
113
Location
London
First Name
Bob
That should look great when it's done, nice idea.
 
G

Graham D

Guest
I have built the catapult into sub-assemblies, to make it easier to paint, even thought the whole thing is grey. The parts are just place for the photos. I decided to buy rail stanchions for the railings on the platform
SubAssembly.jpg SubAssembly1.jpg SubAssembly2.jpg SubAssembly3.jpg SubAssembly4.jpg
 
Top