- Joined
- May 26, 2009
- Messages
- 12,910
- Points
- 113
- First Name
- Ron
Here are some pictures of the finished model. It went together reasonably well, but the decals were very poor.
The harbour wall is made of polystyrene and the sea is clear silicone, shaped with a nail and a coffee stirrer. I experimented with the wave tops and used bits of cotton wool. The disused beacon is made from bits of sprue.
My one regret is I made the landward side of the harbour too short....it's a bit out of balance and an inch or so would have made all the difference....steady!
I'm glad it's finished as I got well fed up knocking bits off the boat!
I hope you like this offering and thanks again for your comments during the build.......
Cheers,
Ron
View attachment 68218
View attachment 68219
View attachment 68220
View attachment 68221
View attachment 68222
View attachment 68223
View attachment 68224
View attachment 68225
View attachment 68226
View attachment 68227
The harbour wall is made of polystyrene and the sea is clear silicone, shaped with a nail and a coffee stirrer. I experimented with the wave tops and used bits of cotton wool. The disused beacon is made from bits of sprue.
My one regret is I made the landward side of the harbour too short....it's a bit out of balance and an inch or so would have made all the difference....steady!
I'm glad it's finished as I got well fed up knocking bits off the boat!
I hope you like this offering and thanks again for your comments during the build.......
Cheers,
Ron
View attachment 68218
View attachment 68219
View attachment 68220
View attachment 68221
View attachment 68222
View attachment 68223
View attachment 68224
View attachment 68225
View attachment 68226
View attachment 68227
Last edited by a moderator: