hi,posted there's a week or so ago,
120mm 3d prints,as you can see there is a lot of horizontal lines,
I have given 3 coats of build filler rattle can stray,and finding ,that I,can still make them out,and losing some detail,
but it dose bring up were it dose,need work of sanding back,
so next thing,is to find some small,dermal tools,as if ,I do with a knife it will end up in my hand,can just see it,
as its very hard plastic,and also need it to ,carve in detail as well,
I would real like to try a vape bath,but need some thing like ethyl acetate,I think,being ALP,unlike ABS,were a vaper bath
of acetone works great in a few sec,s
so maybe some one hear done know what to use ,so any help grateful.
cheers
Moni
120mm 3d prints,as you can see there is a lot of horizontal lines,
I have given 3 coats of build filler rattle can stray,and finding ,that I,can still make them out,and losing some detail,
but it dose bring up were it dose,need work of sanding back,
so next thing,is to find some small,dermal tools,as if ,I do with a knife it will end up in my hand,can just see it,
as its very hard plastic,and also need it to ,carve in detail as well,
I would real like to try a vape bath,but need some thing like ethyl acetate,I think,being ALP,unlike ABS,were a vaper bath
of acetone works great in a few sec,s
so maybe some one hear done know what to use ,so any help grateful.
cheers
Moni
