I'm busy with same brand and scale and model of a very bad tool. The wheel strut components moulding were so bad, I couldn't tell where the flash begins and the part lines end. They were unusable(meaning I'm still a newby and skill not high and very far from an AMS modeller). I was so looking forward to display the engines, but they didn't fit inside the engine compartment at all, had to abandon that I idea and now the prop spinners will have to be glued in place and I lost my temper so bad, I started to cut of exhausts just to see if I could make the exhaust line fit in on the one engine. I've seen on a another thread the tooling you're using, and it's much nicer, which makes it a real shame that a part is missing. Good Luck!