F
funkyrimpler
Guest
Heres a couple of detail pics of the bike i started a couple of days ago. Some of the paint textures look a little grainy on camera but they were taken under a very strong downlight and are actually much flatter in reality.
For the rear brake disc (not yet finished) i used an 0.35mm drill bit and drilled out all the ventilation holes and a slightly larger bit to drill out the centres of the fasteners that attach the disc to the hub.
picture 2 is the rear brake cylinder that is molded as part of the frame.
the handlebars have very fine gauge wire (Hobbycraft) to emulate the lockwires on race bikes.
Theres an assortment of other parts in the pic including front brake calipers, fuel cap etc.
Any feedback or advice gratefully appreciated.
View attachment 48918View attachment 48919View attachment 48920
View attachment 51741
View attachment 51742
View attachment 51743
For the rear brake disc (not yet finished) i used an 0.35mm drill bit and drilled out all the ventilation holes and a slightly larger bit to drill out the centres of the fasteners that attach the disc to the hub.
picture 2 is the rear brake cylinder that is molded as part of the frame.
the handlebars have very fine gauge wire (Hobbycraft) to emulate the lockwires on race bikes.
Theres an assortment of other parts in the pic including front brake calipers, fuel cap etc.
Any feedback or advice gratefully appreciated.
View attachment 48918View attachment 48919View attachment 48920
View attachment 51741
View attachment 51742
View attachment 51743