Feeling a need for a bit of a break, I've been away from the bench for a while. I don't feel like messing with the unfinished Gangut ( yet ), so I looked in the stash for something not too complicated, and I came up with this
Revell reboxing of ICM's 2014 Beech C-45F
A few sprue & detail shots
Nice clean mouldings, no flash. One piece wings will take care of dihedral, but may give a nasty joint to clear up around the engine cowlings.
Seats, in several pieces for each, and decals for belts - not sure about how much will be seen!
Single piece engines
Control panel - again not sure how much will be seen......................
Choice of two decal sets, a RN version from Malta in 1949, and a USAF from 1948. Only difference, colour wise is that the USAF version has yellow cowls - which I think I'll go for.
An all metal finish is always a challenge!
Dave
Revell reboxing of ICM's 2014 Beech C-45F
A few sprue & detail shots
Nice clean mouldings, no flash. One piece wings will take care of dihedral, but may give a nasty joint to clear up around the engine cowlings.
Seats, in several pieces for each, and decals for belts - not sure about how much will be seen!
Single piece engines
Control panel - again not sure how much will be seen......................
Choice of two decal sets, a RN version from Malta in 1949, and a USAF from 1948. Only difference, colour wise is that the USAF version has yellow cowls - which I think I'll go for.
An all metal finish is always a challenge!
Dave