Mk2 Dingo's got sand channel mounts on the front, presumably as a result of crew experiences with the Mk1
I decided to make some sand channels to add as stowage scrounged by the crew
drew up and printed a set of plans
cut out a plan along with a piece of aluminium Pepsi Max (other colas are available) can then CA'd them together
After two failures caused by the drill bit wandering about I decided I needed to punch the centres of all holes
I used the compass point of my Olfa circle cutter to mark all the centres and drilled again
both side of the resulting perforated rectangles were sanded to remove the can coatings and the paper plan
etch bending tool then used to form the sides
hey presto, sand channels
Realised there are no magazines provided for the Bren mag rack so will knock some together
There is a .303 rifle provided that should mount under the rear roof section but no clips provided so that will also need addressing
Apart from the few accessories I think the main build is now complete