Right back.
Spent the morning cutting out some card for the ceilings.
This had to fit inside of course so made up a tape covered jig on the cutting mat.
This it it dropped into the building .
The building itself on the base.
Still have to remove the front paper, but want to do all the internal marking and setting out before this is done.
Having marked where the joists are I then cut the card as the ceiling would have been fine strips of timber then plastered.The area where the damage will be has been sliced as shown.
With the joists on I gave the timbers a slight greyish/ light wood wash. Normally when you take up floor boards there is little change in the joist colour, as there has been no light on them.
The ceiling under the joists its self however would have had a thick layer of dust, cob webs etc.
Under sides of floor boards have been given a light wash.
Some here have been flipped over showing the Nos. The boards will be glued down tomorrow, cutting some to the joist widths as required.
Then the upper surface given a light sanding then a wash of colour.
Thanks for looking in and following.
Comments by all means.
Dzhon.